Eizo FlexScan T2381W Uživatelský manuál stáhnout pdf (Strana 39)

Chapter6Troubleshooting

6-3. Imaging problems (for digital only)

Problem Possible cause and remedy

1. The monitor conguration is changed to

single under the multiple monitor congu-

ration (when DisplayPort is connected).

• WhentwomonitorsareconnectedtoonePCusing

DisplayPort,andthepowertooneofthemonitorsis

turnedoffwiththepowerbutton,thescreensettingmay

bechangedtothesinglemonitorconguration.Insucha

case,enablethe“DPHotPlug”functionwiththefollowing

procedures.Enablingthisfunctionmayincreasethe

powerconsumption.

1. Press

toturnoffthemonitor.

2. Holddown

whilepressing toturnonthemonitor.

Eachtimetheoperationenables/disablesthisfunction

alternatively.

Thecurrentsettingstatuscanbeidentiedbasedonthe

colorusedtodisplaytheinputportorsignalerror.

Setting Input port Signal Error

Disable

(default

setting)

Enable

6-4. Imaging problems (for analog only)

Problem Possible cause and remedy

1. Display position is incorrect. • Use“Position”intheSettingmenutocorrecttheimage

position(see“Tocorrectthescreenposition”(page23)).

• Iftheproblempersists,usethegraphicsboard’sutilityif

availabletochangethedisplayposition.

2. Vertical bars appear on the screen or a

part of the image is ickering.

• Use“Clock”intheSettingmenutoadjustit(see“To

eliminateverticalbars”(page22)).

3. Whole screen is ickering or blurring.

• Use“Phase”intheSettingmenutoadjustit(see“To

removeickeringorblurring”(page23)).

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 69 70

Žádné komentáře

Eizo FlexScan T2381W Uživatelský manuál Strana 39